Revolver Scope Base Rail for Taurus 44 Magnum 607 608 with 6" 8" Non-Ported Vent Rib Barrel
A revolver scope base rail in stainless chrome silver finish for the above listed Taurus revolvers. The rail has 16 ring slots which make it easier to set up eye relief and find more desired placement of scopes or red dot sights on top of the revolver. No drilling is needed. The scope rail is clamped onto the vent rib of the non-ported barrel of 6" to 8" using the hex screws and two steel tabs. The steel tab goes through the openings underneath the vent rib and clamp down by tightening the hex screws. Top rail is compatible with weaver style rings and also will mount red dot sights with weaver style mount. Machined from extruded aluminum alloy. Mounting screws are included with the unit.
Rail type: weaver
Number of ring slots: 16
Overall length: 6 5/8”
Finish: Anodized matte stainless silver
* When mounting the rail onto the revolver, the cantilever end should be pointing toward the hammer side. Check alignment of the rail with the center line of barrel before tightening the clamping screws. Using blue Loctite threadlocker is recommended and check on the screws periodically as they might become loose due to recoil.
Always be sure to unload and practice safe gun handling when mounting the rail.
Not compatible: Taurus Raging Judge 6.5", Taurus Raging Bull, Taurus Tracker 357